21
Optional Components
Listening to the sound
of connected
components
2
1 Prepare the audio components.
2 Press FUNCTION repeatedly until
“TAPE” appears.
Each time you press the button, the function
display changes as follows:
t TUNER t TAPE t CD
To attenuate the distortion from
the connected components
You can change the audio input level for the
TAPE input jacks between two levels.
If the sound from a connected component is
distorted, reduce the input level.
1 Press FUNCTION repeatedly until “TAPE”
appears.
2 Press ?/1 to turn off the system.
3 While holding down x on the unit, press ?/1
on the unit to turn on the system.
“ATT ON” appears in the display.
When the volume is too low, do steps 1 to 3 again
to reset to the original level.
Connecting headphones
Connect headphones to the PHONES jack.
PHONES jack
?/1 (Power)
To Next Page
Loading...
