Sony CMT-LX30IR - Playing Files from USB Devices

CMT-LX30iR.GB.4-131-632-11(1)
22
GB
Playing a le of the
USB device
You can listen to music stored in the USB
device.
e audio formats that can be played
back by this system are as follows:
MP3*/WMA*/AAC*
* Files with copyright protection (Digital
Rights Management) cannot be played back
by this system.
Files downloaded from an online music store
may not be played back by this system.
1 Select the USB function.
Press FUNCTION +/ repeatedly.
2 Connect the USB device to the
(USB) port.
USB device
When the USB device is connected,
the display changes as follows:
“READING”

“STORAGE
DRIVE*”
* When connecting the USB device,
the volume label is displayed next if
recorded.
3 Start playback.
Press  (or  on the unit).
Other operations
To Press
Pause playback  (or  on the
unit). To resume play,
press the button again.
Stop playback . To resume play, press
 (or  on the
unit)*. To cancel resume
play, press  again.
Select a folder
+/ repeatedly.
Select a le /.
Find a point in
a le
Hold down /
during playback, and
release the button at the
desired point.
Select Repeat
Play
REPEAT repeatedly
until “REP” or “REP1”
appears.
* When playing a VBR (variable bit rate) MP3/
WMA le, the system may resume playback
from a dierent point.
To change the play mode
Press PLAY MODE repeatedly while the
USB device is stopped. You can select
normal play (“ ” for all les in the
folder on the USB device), shue play
(“SHUF” or “ SHUF”), or program
play (“PGM”).