Sony CMT-LX30IR - Troubleshooting and Problem Solving; General System and Player Issues

CMT-LX30iR.GB.4-131-632-11(1)
29
GB
Additional Information
Additional Information
Troubleshooting
1 Make sure the power cord and
speaker cords are correctly and rmly
connected.
2 Find your problem in the checklist
below, and take the indicated
corrective action.
If the issue persists, contact your
nearest Sony dealer.
If the STANDBY indicator ashes
Immediately unplug the power cord,
and check the following items.
 If your system has a voltage selector,
is the voltage selector set to the
correct voltage?
 Are you using only the supplied
speakers?
 Is anything blocking the ventilation
holes on the top or back of the
system?
 Is the iPod connector short-
circuited?
Aer the STANDBY indicator stops
ashing, reconnect the power cord,
and turn on the system. If the issue
persists, contact your nearest Sony
dealer.
General
The system does not turn on.
 Is the power cord plugged in?
There is no sound.
 Are the + and  speaker cords short-
circuited?
 Are you using only the supplied
speakers?
 Is anything blocking the ventilation
holes on the top or back of the system?
 e specied station may have
temporarily stopped broadcast.
The STANDBY indicator remains lit
after unplugging the power cord.
 e STANDBY indicator may not turn
o immediately aer unplugging the
power cord. is is not a malfunction.
e indicator will turn o aer about
40 seconds.
Sound comes from one channel,
or the left and right volumes are
unbalanced.
 Place the speakers as symmetrically as
possible.
 Connect only the supplied speakers.
Severe hum or noise.
 Move the system away from sources of
noise.
 Connect the system to a dierent wall
outlet.
 Install a noise lter (available
separately) to the power cord.
Continued
