|
The battery remaining indicator is incorrect, or sufficient battery remaining
indicator is displayed but the power runs out too quickly,
• This phenomenon occurs _hen you use the camera in an extremely hot or cokl location
(page 110).
• The batteries are discharged. Install charged batteries (_ swp 1 in "Read Thi,s Firat').
• The poles of batteries or the terminals of the battery cover are dilly so the batteries arc not
charred sufficiently. Clean them with a cotton swab, etc. (page 110).
• The displayed time remaining differs fiom the current one due to Ihe memory efl_ct
(page 110), etc. Fully discharge and then charge the batteries to correct Ihe display.
• The batteries arc dead (page 110). Replace them with ne_ ones.
The batteries run down too quickly.
• ('barge them sufficiently (_ ,_t+7_l i_ "Re<ulThis First").
• You are using the camera in an extremely cold location (page 110).
• The batteries arc dead (page 110). Replace them with new ones.
Cannot turn on the camera.
• Install the batteries correctly (_ atU_ 1 i_z"Read This First').
• The batteries are discharged. Install charged batteries (_ step 1 irl "Read Thi.s Firat').
• The batteries arc deal (page 110). Replace them with new ones.
The power turns off suddenly.
• If you do not operate the camera for about three minutes _Qfile the pm_er is on. the camera
turns off automatically to prevent wearing down the batteries. Turn on the camera again (_
step 2 in "Ream This Firft' ).
• The batteries are discharved. Install charged baNeries (-+ .step 1 in "Read Th_s First").
The LCD screen does not turn on even when the power is turned on.
• The finder is turned on. Turn on the LCD screen using the FINDER/LCD button l_ ._t,7_.5irl
"Read This Fi_:_t').
The image is not clear on the finder,
• A(liust the diopter scale properly using the finder a_[justmentdial (_ ._t,7_.5irl "Read Thia
Firat ').
g4