Sony Cyber-shot DSC-RX100M3 - Evf Block Section

DSC-RX100M3/RX100M3G_L2
2-9
2-1-6. EVF BLOCK SECTION
ns : not supplied
Ref. No. Part No. Description
Ref. No. Part No. Description
253 X-2589-679-1 COVER ASSY, EVF
254 A-2059-547-A VF SUB ASSY (SERVICE) (Note 2)
255 A-2045-282-A EV-1010 BOARD, COMPLETE
256 X-2589-081-1 ASSY, EVF LAUNCH
257 4-541-852-01 SHEET, SWITCH PROTECTION
258 4-541-619-01 TAPE (ST), SHIELD
259 A-2059-646-A ST-1023 FLEXIBLE BOARD, COMPLETE (SERVICE)
(Note 3)
260 CAUTION SHEET (ANT), ADHESIVE
261 4-479-099-01 BASE, ANTENNA
262 CAUTION SHEET (ANT) (710), ADHESIVE
264 4-528-630-01 BASE HOLDER LAUNCH
265 4-534-390-01 INSULATING SHEET (MAIN CON)
266 4-541-432-01 PULL STICKER
267 CAUTION FLEXIBLE, ADHESIVE SHEET (LC)
268 4-548-037-01 SPACER, EVF SHEET
ANT901 A-1975-721-A ANTENNA (SERVICE), NFC
C901 1-118-962-11 CAP, ALUMINIUM ELECT 30uF 315V
C902 1-118-961-11 CAP, ALUMINIUM ELECT 20.5uF 315V
#196 4-178-124-01 SPECIAL (M1.4 (D2.75)) (Note 1)
#239 4-287-435-11 SCREW (M1.4 EUROPE) TYPE (Note 1)
#247 4-412-769-11 SCREW (M1.4), NEW TRU-STAR, P2 (Note 1)
#312 4-448-213-01 SCW ,0+P2 P1.4 (black)
(Claw)
(Bosses)
(Bosses)
(Bosses)
(Boss)
A
A
Lens Block Section
(See page 2-11)
(Note 4)
256
259
255
266
268
254
253
264
258
267
257
ANT901
262
261
260
260
265
ns
#196
(Note 1)
#247
(Note 1)
#239
(Note 1)
#312
#312
(Note 3)
(Including LCD902)
(Note 2)
#312
ns
#312
C901
C902
フラッシュ用充電コンデンサの放電
DISCHARGING OF THE CHARGING CAPACITOR
(Size : 3.0 X 8.5 mm)
1. The meaning of the symbol in left figure is as follows. Be careful when you remove it.
◇-X: Solder
DISASSEMBLY
Screw
#196: M1.4 X 2.0
(Black)
4-178-124-01:
2.0
1.4
#239: M1.4 X 1.4
(Red)
4-287-435-11
1.4
1.4
#312: M1.4 X 3.5 (Tapping)
(Black)
4-448-213-01
1.4
3.5
Note
Note 2: Refer to “Assembly-3: Notes on assembling the VF Sub Assy
(Service)” when assembling.
Note 2:
 組立時は“Assembly-3: Notes on assembling the VF Sub Assy
(Service)”を参照してください。
Note 1: This screw cannot be reused. Discard the screw removed once
in servicing. Instead, use a new screw.
Note 1:
 このねじは再利用することができません。サービス対応時に一
度でも外した場合は新品のねじと交換してください。
CAUTION
For the part of 260: Adhesive Sheet (ANT), 262: Adhesive Sheet (ANT)
(710) and 267: Adhesive Sheet (LC) Flexible, cut the Adhesive Sheet
(2-649-300-01) into the desired length and use it.
注意
260: Adhesive Sheet (ANT)，262: Adhesive Sheet (ANT) (710) と267:
Adhesive Sheet (LC) Flexibleは，Adhesive Sheet (2-649-300-01) を切っ
て使用すること。
Note 3: Refer to “Assembly-4: Notes on assembling the ST-1023 Flex-
ible Board” when assembling.
Note 3:
 組立時は“Assembly-4: Notes on assembling the ST-1023
Flexible Board”を参照してください。
Note 4:
Hold the Lens Block at the
center of both sides.
Do not hold the following part.
Hold here.
NOTES ON HOLDING THE LENS BLOCK
Lens barrier
*Very weak
Zoom motor,
Gear B
*Very weak
G10 lens
*Very weak
#247: M1.4 X 2.5
(Black)
4-412-769-11
2.5
1.4
The changed portions from
Ver. 1.0 are shown in blue.
Ver. 1.1 2015.01
SYSSET
2018/10/1703:17:13(GMT+09:00)