Sony Cyber-shot DSC-RX100M3 - Disconnecting the product from the computer

Back Back to Top Print
Go to Page Top
Digital Still Camera
DSC-RX100M3
Disconnecting the product from the computer
Disconnects the USB connection between this product and the computer.
Perform the procedures from step 1 to 2 below before performing the following operations:
Disconnecting the cable.
Removing a memory card.
Turning off the product.
1. Click
(Safely remove USB Mass Storage Device) on the taskbar.
2. Click the displayed message.
Note
For Mac computers, drag and drop the icon of the memory card or the drive icon in the “Trash” icon. The product is
disconnected from the computer.
For Windows 7/Windows 8 computers, the disconnect icon may not appear. In that case, you can skip steps 1 and 2
above.
Notes on use
4-539-041-13(1)
Copyright 2014 Sony Corporation
Help Guide
How to Use
405