Sony Cyber-shot DSC-RX100M3 - The product does not work properly.

Back Back to Top Print
Go to Page Top
Digital Still Camera
DSC-RX100M3
The product does not work properly.
Turn off the product. Remove the battery pack and insert it again. If the product is hot, remove the battery pack, and
allow it to cool down before trying this corrective procedure.
If an AC-UD10/AC-UD11 AC Adaptor (sold separately) is used, disconnect the power cord. Connect the power cord
and turn on the product again. If the product repeats the same error often or still does not work after trying these
solutions, consult your Sony dealer or local authorized Sony service facility.
Notes on use
4-539-041-13(1)
Copyright 2014 Sony Corporation
Help Guide
Troubleshooting
489