Sony DCU-8000 - Installing the HK-PSU03

1-6
DCU-8000 IM
1-4-3. Installing the HK-PSU03
The HK-PSU03 is used after it is installed in the MKS-
8700.
n
Be sure to turn off the POWER switch before starting
installation work.
If installation work is started with the POWER switch left
on, it may cause electrical shock or damage to printed
circuit boards.
Installation
1. Remove the front panel. (Refer to Section 1-4-1)
2. Loosen the two screws fixing the blank panel of the
slot to which you want to install the HK-PSU03.
Remove the blank panel.
n
Store the removed blank panel in a safe location.
3. Install the HK-PSU03 firmly as far as it will go.
4. Secure the HK-PSU03 with the two screws.
1-4. Installing the Options
B3 x 5
Blank panel
B3 x 5
HK-PSU03