Sony DFS-900M - Option Board Information; Software Version Information; Alarms

171
Status Information
Chapter 8 Other Operations and Settings
Option Board Information
The Board In/Out/Op1/Op2 sub menus allows you to
check whether option boards are installed.
Software Version Information
The Firmware sub menu allows you to check software
version information.
The software name and version information appear in the
display areas of the F1 to F4 knobs.
Alarms
The Alarm sub menu allows you to check the various
alarms.
Knob Parameter Description Settings
F1 Displays
information about
the board(s) in
input expansion
slots.
s: 4SDI Input
Board
a: SD analog
input board
d: DVI input
board
-: Not installed
F2 Displays
information about
the board(s) in
output expansion
slots.
s: 4SDI Output
Board
a: SD analog
output board
d: DVI output
board
-: Not installed
F3 Displays
information about
the board(s) in
the DME1 and
DME2 sockets.
dme: 2CH DME
Board
-: Not installed
F4 Displays
information about
the board(s) in
the MV1 and MV2
sockets.
mv: Multi Viewer
Board
-: Not installed
Knob Parameter Description Settings
F1 PWR Displays
information about
the installed
power supply
unit(s) in the
processor unit.
Single A: Only
one standard
power supply
unit is
installed.
Single B: Only
one optional
power supply
unit is
installed.
Dual: Both a
standard and
an optional
power supply
unit are
installed.
F2 PS Displays the
alarm status of
the power supply
unit(s) in the
processor unit.
ok: Operation is
normal.
ng: An error has
been detected.
F3 FN Displays the
alarm status of
the fan.
ok: Operation is
normal.
ng: An error has
been detected.
F4 CP Displays
information about
the installed
power supply
unit(s) in the
control panel.
ok: Operation is
normal.
ng: An error has
been detected.
Knob Parameter Description Settings