199
Messages and Actions to Take
Appendix
File read error Appears in the following cases.
a) Loading of the file failed during
a still image file download.
b) Loading of the signal name data
failed when display of multi-view
signal names is on.
a) Try downloading the still image
file again.
b) Reset the settings of the output
video, and try turning the
display of signal names off and
on again.
Gray scale loaded Gray scale file loaded Appears when an 8-bit gray scale
still image file is loaded.
Select a still image file in another
format.
Include Wrong DME No Appears when you attempt to
recall a user pattern, sequence, or
event that uses an effect not
supported by this version.
Backgrounds and keys 1 to 4 are
not recalled if they include effects
not supported by this version.
Save the user pattern, sequence,
or event after modifying it to use
only supported effects, and then
recall it again.
No assignable DME Appears when an attempt is made
to change a transition type from a
non-DME effect to a DME effect,
even though the maximum number
of DME channels are already in
use.
Reduce the number of DME
channels and try the operation
again.
No free memory Appears when the control panel
OS has no free memory.
Wait for a while and try the
operation again.
No KeyFrame Appears when an attempt is made
to delete the current keyframe from
a sequence when the target
keyframe does not exist.
Select another keyframe.
No more KeyFrames No more KeyFrames
available
Appears when an attempt is made
to register a new keyframe when
the maximum number of
keyframes has already been
registered in a sequence, or when
an attempt is made to change the
current keyframe to higher than the
maximum number of registered
keyframes.
Delete one or more keyframes and
try again.
No Option Appears when you switch to the
MV1 or MV2 sub menu with no
BKDF-950 installed.
Install a BKDF-950.
No specified SEQ No specified SEQ file Appears when the specified
sequence file cannot be found.
Specify another sequence file.
No specified Still No specified Still file Appears when the specified still
image file cannot be found.
Select another still image file.
No system-data file Appears when system data file
cannot be found.
Select the system data and try the
operation again.
No update file No specified update file Appears when the specified
update file cannot be found.
Check to make sure that the
specified update file exists on a
USB flash drive connected to the
USB MEMORY connector, and
then try the operation again.
No USB Device USB Appears when no USB flash drive
is connected.
Connect a USB flash drive.
No User Pattern Appears when you recall an event
that uses a wipe or DME user
pattern if the user pattern is not
registered.
Recall an unregistered user
pattern by specifying 0 as pattern
number.
Register the user pattern used by
the event and then recall the event
again.
Message Description Action to take
Display panel GUI menu screen
To Next Page
Loading...
