2-1
DSC-F55/F55E
SECTION 2
DISASSEMBLY
NOTE: Follow the disassembly procedure in the numerical order given.
The following flow chart shows the disassembly procedure.
2-1. CABINET (FRONT) ASSEMBLY AND CHECK COVER
1
Screw (lock ace M1.7)
7
Check cover
(Refer to Fig 1)
2
Two screws (lock ace M1.7)
3
Two screws (lock ace M1.7)
Remove the check cover by rotating
the metal bar in the direction of the
arrow of ø1.6 or less centering around
the point “P”.
Note: Do not reuse the check cover
that is once removed.
5
Harness (SV-110)
CN605 2P (SY-54 board)
4
Connector
CN001 3P (MM-39 board)
6
Cabinet (front) assembly
P
(Fig 1)
DSC-F55/F55E
2-3. LENS CABINET ASSEMBLY 2-5. MM-39, SY-54 BOARDS
2-1. CABINET (FRONT) ASSEMBLY
AND CHECK COVER
2-2. DD-126 BOARD
2-6. CONTROL SWITCH BLOCK (MS) / (HF)
2-4. LENS ASSEMBLY,
MICROPHONE, FLASH UNIT
2-7. LCD PANEL BLOCK
SERVICE POSITION 1
(FLASH UNIT, LENS BLOCK)
SERVICE POSITION 2
DD-126 BOARD, MM-39 BOARD,
SY-54 BOARD, LCD PANEL BLOCK
Downloaded from: https://www.usersmanualguide.com/
To Next Page
Loading...
