2-3
[ SERVICE POSITION 1 (FLASH UNIT, LENS BLOCK) ]
Flash unit
Lens block
CPC-9 jig
(J-6082-393-C) (Note 2)
Battery box
Base
Base
AC power
adaptor
Adjustment remote
commander (RM-95)
Note 1: The built-in charging capacitor inside the FLASH unit is charged to the maximum of 300 V.
There is a danger of electric shock due to the high voltage when the battery is handed by
bare hand. Discharge the voltage remained in the battery, referring to the Service Note (See page 5).
Note 2: The old CPC-9 jig (Parts code: J-6082-393-B)
cannot be used, because it cannot operate
the adjustment remote commander.
2-4. LENS ASSEMBLY, MICROPHONE, FLASH UNIT
1
Two screws (tapping head (2 lock) )
4
Two screws (tapping head (2 lock) )
2
Lens assembly
5
Microphone retainer
7
Microphone cushion
Be careful when handling
it as it is not fixed.
6
Microphone unit
3
Flash unit
(Remove the three claws as shown.)
Note : The built-in charging capacitor inside the FLASH unit is charged to the maximum of 300 V.
There is a danger of electric shock due to the high voltage when the capacitor is handed by
bare hand. Discharge the voltage remained in the capacitor, referring to the Service Note (See page 5).
Downloaded from: https://www.usersmanualguide.com/
To Next Page
Loading...
