2-5
2-7. LCD PANEL BLOCK
[ SERVICE POSITION 2 (DD-126 BOARD, MM-39 BOARD, SY-54 BOARD, LCD PANEL BLOCK) ]
A
B
Claw
LCD panel block
• Open the cabinet in the direction of the arrow
A
as shown, release the claw of the LCD
display panel block, and remove the LCD panel block in the direction of the arrow
B
.
Lens block
Control switch block (HF)
Control switch block (MS)
Battery box
DD-126 board
LCD panel block
AC power
adaptor
CPC-9 jig
(J-6082-393-C) (Note)
Adjustment remote
commander (RM-95)
Thick isolation sheet
MM-39 board
Extension cable (80P)
(J-6082-444-A)
Note: The old CPC-9 jig (Parts code: J-6082-393-B) cannot be used,
because it cannot operate the adjustment remote commander.
Downloaded from: https://www.usersmanualguide.com/
To Next Page
Loading...
