Sony DSC-F717 - Auto White Balance Adjustments

DSC-F717
6-22
10. Auto White Balance 3200K Standard Data Input 2
RadarWRadarWRadarW
Adjust the white balance standard data at 3200K.
Mode CAMERA
Subject Clear chart
(Standard picture frame with the
zoom lens at WIDE end)
Adjustment Page F
Adjustment Address 7A to 7F
Note 1: Perform this data input after performing “Auto White
Balance 3200K Standard Data Input 1”.
Note 2: Check that the data of page: 6, address: 02 is “00”.
If not, turn the power of unit OFF/ON.
Note 3: “Auto White Balance 3200K Standard Data Input 2” is
available only once after the power is turned on. Turn the
power off, then on again if the adjustment is retried.
Adjusting method:
Order Page Address Data Procedure
1
“Auto White Balance 3200K
Standard Data Input 1” is
completed.
2 6 37 04
3 6 01 0B Press PAUSE button. (Note 4)
46 02
Check the data changes to
“01”.
Note 4: The adjustment data will be automatically input to page:
F, address: 7A to 7F.
Processing after Completing Adjustment:
Order Page Address Data Procedure
1 6 01 00 Press PAUSE button.
2
Perform “Auto White
Balance 3200K Standard
Data Input 3”.
9. Auto White Balance 3200K Standard Data Input 1
RadarWRadarWRadarW
Adjust the white balance standard data at 3200K.
Mode CAMERA
Subject Clear chart
(Standard picture frame with the
zoom lens at WIDE end)
Adjustment Page F
Adjustment Address 70 to 79, B0, B2, B4
Note 1: Check that the data of page: 6, address: 02 is “00”.
If not, turn the power of unit OFF/ON.
Note 2: “Auto White Balance 3200K Standard Data Input 1” is
available only once after the power is turned on. Turn the
power off, then on again if the adjustment is retried.
Adjusting method:
Order Page Address Data Procedure
1
Perform “Data setting during
camera system adjustment”.
(Refer to page 6-14)
2
Perform “Picture Frame
setting”. (Refer to page 6-15)
3 6 37 01
46 B603
5 6 01 11 Press PAUSE button.
66 38
Check the data changes to
“01”.
7 6 01 C1 Press PAUSE button. (Note 3)
86 02
Check the data changes to
“01”.
9 6 01 00 Press PAUSE button.
10 6 B6 00
11 6 37 02
12 6 01 0B Press PAUSE button. (Note 3)
13 6 02
Check the data changes to
“01”.
Note 3: The adjustment data will be automatically input to page:
F, address: 70 to 79, B0, B2 and B4.
Processing after Completing Adjustment:
Order Page Address Data Procedure
1 6 01 00 Press PAUSE button.
2
Perform “Auto White
Balance 3200K Standard
Data Input 2”.