Sony DSC-F828 - 1-5. Color Electronic Viewfinder Adjustment

6-31
DSC-F828
1-5. COLOR ELECTRONIC VIEWFINDER
ADJUSTMENT
Note1: When replacing the LCD unit, be careful to prevent damages
caused by static electricity.
Note2: If you perform the adjustments with FINDER/LCD switch (Control
switch block (UNDER)) removed, set the following data.
1) Select page: 80, address: 10, and set data: 1A.
2) Select page: 80, address: 11, and set data: 01.
Reset the data after completing adjustment.
1) Select page: 80, address: 10, and set data: FF.
2) Select page: 80, address: 11, and set data: 00.
Switch setting:
FINDER/LCD .......................................................... FINDER
1. Data Setting during EVF System Adjustments
Perform the following data setting before the EVF system
adjustments.
Note: When the power is turned off, some data settings will be released.
So perform this data setting again when the power is turned off.
Order Page Address Data Procedure
1 00 01 01 Set the data.
2 80 70 01 Set the data.
After completing the EVF system adjustments, release the data
setting.
Order Page Address Data Procedure
1 80 70 00 Set the data.
2 Save the data.
3 Wait for 2 sec.
4 00 01 00 Set the data.
2. EVF Initial Data Input
Mode PLAY ( )
Signal Arbitrary
Adjustment Page 8F
Adjustment Address 70, 71, 73 to 78, 7A, 7C
Adjusting method:
1) Select page: 00, address: 01, and set data: 01.
2) Select page: 8F, and set the data in the following table.
3) Save the data.
4) Wait for 2sec.
5) Select page: 00, address: 01, and set data: 00.
Address
70
71
73
74
75
76
77
78
7A
7C
Remark
Fixed data
Fixed data
VCO adj.
V COM adj.
Bright adj.
Fixed data
Fixed data
White balance adj.
White balance adj.
Contrast adj.
53
96
80
A4
8D
40
00
90
80
38
Data