When the desired access point is not displayed on the screen: Select [Manual
Setting] and set the access point.
*
For the input method, refer to “How to use the keyboard.”
If you select [Manual Setting], input the SSID name of the access point, then select
the security system.
3. Input the password, and select [OK].
Access points without the mark do not require a password.
4. Select [OK].
How to use the keyboard
When manual character entry is required, a keyboard is displayed on the screen.
1. Input box The characters you entered are displayed.
2. Switch character types Each time you press on the center of the control wheel,
the character type switches among alphabet letters, numerals and symbols.
3. Keyboard Each time you press on the center, the character that you enter will be
displayed.
For example: If you want to enter “abd”
Select the key for “abc” and press once to display “a” → select “ ”((5) Move
cursor) and press → select the key for “abc” and press twice to display “b” →
select the key for “def” and press once to display “d”.
4. Finalize Finalizes the entered characters.
5. Move cursor Moves the cursor in the input box to the right or left.
6. Delete Deletes the character preceding the cursor.
7. Switches the next character to a capital or small letter.
To Next Page
Loading...
