Sony DSC-W830 Service Manual

DSC-W830
3-1
3. SERVICE NOTE
3-1. PRECAUTION ON REPLACING THE SY-1035 BOARD
DESTINATION DATA
When you replace to a board for service, the written destination data of the board for service also might be changed to original setting.
Start the Adjust Manual in the Adjust Station and execute the “Destination data write”.
RESTORE DATA
When you replace to a board for service, get the data from the former one.
Start the Adjust Manual in the Adjust Station and execute the “RESTORE DATA” to get the data.
The data getting for this model is as follows.
• PRODUCT ID & USB SERIAL No.
• Hash data setting
• AWB standard data input & check, Color reproduction check
USB Serial No. and Product ID
The unit is shipped after an ID (USB Serial No.) unique to each unit and an ID (Product ID) unique to each model have been written.
These IDs have not been written in a new board for service, and therefore they must be entered after the board replacement.
After the board has been replaced with a board for service, start the Adjust Manual in the Adjust Station and execute the “PRODUCT ID &
USB SERIAL No. INPUT” and enter these IDs.
Note: A newly entered Product ID is not always equal to the ID before board replacement. If the new ID differs from the previous ID, it may cause a difference
from the ID registered by the customer.

Sony DSC-W830 Specifications

General

Sensor Resolution	20.1 MP
Optical Zoom	8x
Lens Type	Carl Zeiss Vario-Tessar
Image Stabilization	Optical SteadyShot
LCD Screen Size	2.7 inches
Maximum Video Resolution	1280 x 720 (720p)
Sensor Size	1/2.3 inch
Image Sensor	Super HAD CCD
ISO Range	ISO 80-3200
Focal Length	4.5-36 mm
Digital Zoom	32x
LCD Resolution	230, 400 dots
ISO Sensitivity	Auto, 80, 100, 200, 400, 800, 1600, 3200
Battery Type	NP-BN
Dimensions	93.1 x 52.5 x 22.5 mm
Aperture	f/3.3 - f/6.3
Shutter Speed	2 to 1/1600 sec
Storage Media	Memory Stick Duo; SD/SDHC/SDXC