Sony DSLR-A100 - Tools to be Prepared; Slant Sensor Switch Operation Inspection

1-3E
DSLR-A100_L2
Tools to be prepared:
Magnet (cover with a tape, etc. for damage prevention)
Demagnetizer
Push a magnet to the right side of MENU button to
demagnetize.
In the state shown below, operate the demagnetizer for 5 seconds,
and with the demagnetizer operated, detach it in the arrow direction.
At this time, hold the magnet in same position, and remove it after
the demagnetizer was detached.
MENU Button
Magnet
Demagnetizer
STEP 2:
STEP 1:
Push a magnet to the side of Display button (side surface
of the camera) to demagnetize.
In the state shown below, operate the demagnetizer for 5 seconds,
and with the demagnetizer operated, detach it in the arrow direction.
At this time, hold the magnet in same position, and remove it after
the demagnetizer was detached.
Display Button
Magnet
Demagnetizer
STEP 3:
Push a magnet over the Playback button to demagnetize. In the state shown below, operate the demagnetizer for 5 seconds,
and with the demagnetizer operated, detach it in the arrow direction.
At this time, hold the magnet in same position, and remove it after
the demagnetizer was detached.
Magnet
Playback Button
Demagnetizer
• SLANT SENSOR SWITCH OPERATION INSPECTION
Using the camera already demagnetized, perform the posture switching by five sets, one set comprising “normal posture → Grip up →
Grip down”, to confirm that the LCD display changes over correctly.