Fordetailsontheoperation_ page80
Before deleting images or folders, a confirmation screen, such as "Delele Ihis image?",
appears. Normally. [No] is selected by' default, but you can set this default option so that [Yes]
is selected.
"Yes" [Yes] is selected by' defimll.
"NO" [No] is selecled by default.
• This setling applies 1o bolh deleting images and toklers.
If dust or debris enters the camera and lands on the CCD (the part that acts as the film), it may
appear on the photo image, depending on the shooting environment. If there is dust on the
CCD. use a commercially available blower brush and clean the CCD following the steps
below. You can easily brush the dust away using only the blo'_ er brush and the anti-dust
function.
• Cleaning can be performed only when the battery level is _[_, Low battery power
during cleaning can cause damage to the shutter. The cleaning should be
completed quickly.
(_) Confirm that the battery is fully charged.
• Tile use of an AC Adaptor/chalger (nolsupplied) is recommended.
(g) Select [Clean CCD], then select [Enter].
The message "After cleaning the CCD, turn camera off. Continue?" appears.
(_) Select [Yes] with • on the controller, and press the center of the controller.
• Alter tileCCD vibrales tot a shorttime, die mirror in ffonl is lifted.
(_) Detach the lens.
(_) Use the bh)wer brush to clean the CCD surface and the surrounding area.
• Do mU touch file CCD wilh tile tip of the brush. Complete the cleaning quickly.
• Hold the calnera's lace downward to prevent tile dusl flolll re_ttling ill tile camera,
• Do nol iise a spray blower becatlse il may scauer vapor inside lhe camera body,
103
To Next Page
Loading...
