Cannot
print
the
image
at
the
size
selected.
• Disconnect the USB cable and reconnect it whenever you change the paper
size after the printer has been connected to the camera.
• The print setting
of
the camera differs from that
of
the printer. Change the
setting
of
either the camera (page 144) or the printer.
Cannot
operate
the
camera
after
canceling
printing.
• Wait for a while as the printer is carrying out the cancellation.
It
may take
some time depending on the printer.
The
lens
gets
logged.
• Moisture condensation has occurred. Tum
off
the camera and leave it for
about an hour before using it (page 163).
The
message
"Set
date
and
time?"
appears
when
you
turn
on
the
camera.
• The camera has been left unused for sometime with a low battery or no
battery pack. Charge the battery pack and set the date again (page 25).
If
the
date setting is lost every time the battery pack is charged, consult your Sony
dealer or local authorized Sony service facility.
The
number
of
recordable
images
does
not
decrease
or
decreases
two
at
a
time.
• This is because the compression rate and the image size after compression
change depending on the image when you shoot a
lPEG
image (page 115).
The
setting
is
reset
without
the
resetting
operation.
• The battery pack was removed when the POWER switch was set to ON.
When removing the battery pack, make sure the POWER switch is set to
OFF and the access lamp is not illuminated (page 25).
The
camera
does
not
work
properly.
•
Tum
off
the camera. Remove the battery pack and insert it again.
If
an AC
Adaptor/charger (not supplied) is used, disconnect the power cord.
If
the
camera is hot, allow it to cool down before trying this corrective procedure.
If
the camera does not work after doing these solutions, consult your Sony
dealer or local authorized Sony service facility.
•
o
-
:r
CD
....
en
159
To Next Page
Loading...
