Sony DSLR-A350 - To Remove the Lens; Note on Changing the Lens; If Dust or Debris Lands on the Image Sensor

To remove the lens
1 Press the lens release button all
the way in and turn the lens
counterclockwise until it stops .
• When changing the lens, quickly
change the lens away
from dusty
locations so as
to keep dust from
getting inside the camera.
2 Replace the cap on the lens and
attach the body cap to the
camera .
• Before you attach the cap, remove dust
from the cap.
Lens release button
Note on changing the lens
When changing the lens, if dust or debris gets inside the camera and lands
on the surface
of the image sensor (the part that acts as the film), it may
appear on the image, depending on the shooting environment.
The camera is equipped with an anti-dust function to prevent dust from
landing on the image sensor. However, quickly change the lens away from
dusty locations when attaching/removing a lens.
If dust or debris lands on the image sensor
Clean the image sensor using [Cleaning mode] in the" Setup menu
(page 32).
20