When shooting with the flash, you can adjust the amount
of
flash light
alone, without changing the exposure compensation. You can only change
the exposure
of
a main subject which
is
within the flash range.
MENU
button
-+
0 1
-+
[Flash
compens.l
-+
Select
the
desired
seUing
• Toward +: Makes the flash level higher.
Toward
-:
Makes the flash level lower.
Notes
•
If
you have adjusted the flash level,
~
appears on the LCD monitor/in the
viewfinder when the built-in flash is pulled up. When you adjust it, be careful not to
forget to reset the value.
• The positive effect may not be visible due to the limited amount
of
flash light, if the
subject is at or around the maximum range for the flash. If the subject is very close,
the negative effect may not be visible.
Exposure
compensation
and
flash
compensation
Exposure compensation changes the shutter speed, aperture, and ISO sensitivity (when
[AUTO] is selected) to perform the compensation.
If
the flash is used, the amount
of
flash light is also changed.
However, flash compensation only changes the amount
of
flash light.
MENU
button
-+
~
1
-+
[Flash
control]
-+
Select
the
desired
setting
ADI
flash
This method controls the lighting
of
the flash, factoring
in
the
focus distance information and light metering data from the
pre-flash. This method enables an accurate flash
compensation with virtually no effect from the reflection
off
the subject.
Pre-flash
TTL
This method controls the amount
of
flash light depending on
the data only from pre-flash light metering. This method is
susceptible to the reflection
off
the subject.
88
To Next Page
Loading...
