To
remove
the
lens
Pres the lens release button all the way
in
and tum the lens counterclockwise untiI
it
stops.
iii+';-;:;*-
Lens release button
• Replace the cap on the lens and attach the body cap (or another lens) to the camera afler removing the lens.
Keep
dust
from
getting
inside
the
camera
when
changing
lenses!
If
dust or debris gets inside the camera and lands on the surface
of
the image sensor (the
part that acts as the film), it may appear on the image, depending on the shooting
environment.
The
camera
is
equipped with an anti-dust function to prevent dust from landing on the
image sensor. However, take note
of
the following reminders when attaching/removing a
lens.
• Avoid changing lenses
in
a dusty location.
• When storing the camera, always attach a lens or the body cap.
• When attaching the body cap, remove all the dust from the cap before placing
it
on the camera.
If dust or debris gets inside the camera, select [Cleaning mode]
in
the
~
Setup menu, and
use a commercially available blower brush to clean the image sensor.
--+
"User's Guide!
TroubLeshooting" (page 125)
7
To Next Page
Loading...
