Super
SteadyShot
function
1 Make sure that the
(11)1
(Super SteadyShot) switch
is
set to ON to activate the function.
2 Press the shutter button halfway down, and then press it fully down.
«-1)1
(Super
*-+--H'1'- SteadyShot)
switch
-
,
(D)
,
-
•
'0
35
...
~
....
~
«<IIilI
(Camera-shake
warning) indicator
...
Super SteadyShot
scale
14
....1
Super
SteadyShot
scale
This scale
is
displayed whenever the Super SteadyShot function
is
activated. A higher scale
indicates more pronounced camera-shake (on a scale
of
five).
When the Super SteadyShot function
is
deactivated, the scale will not be displayed.
oc<llill
(Camera-shake
warning)
indicator
This indicator flashes regardless
of
the status
ofthe
Super SteadyShot function.
It
indicates the
likelihood
of
camera-shake calculated from the shutter speed and focal length.
If
the indicator
flashes, reduce the camera-shake by setting the
«-I»
(Super SteadyShot) switch
to
ON or
using the built-in flash or a tripod.
• The Supcr SteadyShol funclion may not work optimally when
the
power has just been turned on, when the
subject has just entered the frame, or when the shuller bUllon has been pressed all the way down without
stopping halfway. Wait for the Super SleadyShot scale to go down, and then press the shuller bUllon down
slowly.
• Since lhe Super SleadyShol function is less effective
in
the following cases, mount lhe camera
on
a tripod.
-Shooting
a
subjeclthat
is
localed within a very close range.
-Shooting
a moving subject
-Shooting
with shutter speeds
of
1/4
second or longer, which are typically used
in
night-time shooting.
• When using a tripod, deaclivate the Super SteadyShot function as
it
will nol be fully effeclive.
• This Super SleadyShOl function can reduce the effect
of
camera-shake by the equivalent
of
approximately
2.5
104
increments
of
shuller speed.
To Next Page
Loading...
