CD
Set the mode dial
to
P.
® Hold the grip and look into the viewfinder or press the shutter button halfway down until the
shutter speed and aperture value are displayed in the viewfinder.
® While the shutter speed and aperture value are displayed, select the shutter speed using the front
control dial or select the aperture value using the rear control dial.
Mode dial ---;::,:::::'
P
s
shift
Front control dial
Shutter button
':"'-'-'~:"----
Rear control dial
•
[~
1/12f@-=:=]
~
1-
I~-"":"""~
I
~m,
Rear control
125
@
-2""'~'1-02+
l..f
.,
dial
Y
.1
Front control ®
3.2
dial
---==---------
• You can switch the P
s
shift and the PA shift with [Ctr! dial setup] in the 0 Custom menu (page 107).
• When the shutter speed and the aperture value are displayed, you no longer have to keep pressing the
shutter button.
• When the shutter speed and the aperture value disappear seconds later, the adjusted values also disappear.
• When the flash is pulled up, you cannot select the program shift. When the program shift
is
turned on,
pulling up the flash cancels the program shift.
SUoDting
will alellreItiQril
maile
-I
You
can
adjust the aperture manually.
If
you open the aperture (a smaller F-number), the in-
focus range
becomes
narrower.
Only
the main subject is then in focus.
When
the aperture is
closed (a larger F-number), the in-focus range becomes wider.
The
whole
image
is sharpened.
The
shutter speed is automatically adjusted.
Open the aperture
Close the aperture
37
To Next Page
Loading...
