44
CD
Set the mode dial
to
M.
® Rotate the front control dial
to
the left until
[BULB]
is indicated.
~~~~--=·5...:....::.6=---'----1
11:Cl-
3
"2"1"O"1"2"3+
I
~
DlrDJl:=I~lm
~
I
Awe
~9O'Ii1
FINE
I
CL
llim
100
@ Rotate the rear control dial
to
select the aperture.
o Attach the eyepiece cover (See below).
® Press and hold the shutter button for the duration
of
the shooting.
• You can shoot
in
bulb exposure mode up to about four and a
half
hours using a fully charged battery pack.
• After shooting, the noise reduction will be done for the same amount
of
time that the shutter was open.
When the message "Processing..." appears, you cannot do any further shooting. You can cancel this
function with [Long exp.NR]
in
the
~
Recording menu (page 103).
• The Super SteadyShot function is automatically turned off.
• The higher the ISO sensitivity, or the longer the exposure time, the more outstanding the noise on the
monitor.
• To reduce camera-shake, connecting the Remote Commander is recommended (pages 60, 166).
To attach the eyepiece cover
When the shutter is released without the use
of
the viewfinder, as
in
bulb exposure or shooting with the
self-timer, attach the eyepiece cover to prevent light from entering through the viewfinder and affecting
the exposure.
CD
Carefully slide the eyecup off
by
pushing on each side
of
the eyecup.
® Slide the eyepiece cover over the viewfinder. The cover
is
normally attached to the shoulder
strap.
To Next Page
Loading...
