Need help?Do you have a question about the Sony DT 16-50mm F2.8 SSM and is the answer not in the manual?
General| Focal Length | 16-50mm |
|---|---|
| Maximum Aperture | f/2.8 |
| Minimum Aperture | f/22 |
| Lens Mount | Sony A-mount |
| Format | APS-C |
| Maximum Magnification | 0.2x |
| Filter Diameter | 72 mm |
| Weight | 577 g (1.27 lb) |
| Lens Type | Zoom lens |
| Image Stabilization | No |
| SSM | Yes |
| Angle of View | 83° - 32° |
| Optical Design | 16 elements in 13 groups |
| Focus Type | Auto |
| Minimum Focus Distance | 0.3 m (0.99 ft) |
| Dimensions | 81 x 88 mm |
| Diaphragm Blades | 7 |
Remove the rear and front lens caps and the camera body cap.
While holding down the lens release button on the camera, rotate the lens counterclockwise until it stops, then detach the lens.
This prevents the lens barrel from extending due to the weight of the lens while it is carried.
Focusing can be switched between AF and MF on the lens.
Slide the focus-mode switch to the appropriate mode, AF or MF.
Press the AF/MF control button to switch AF to MF when both the camera and lens are set to AF.
Rotate the focusing ring to set the correct DMF when the focus is locked in AF-A or AF-S.
The focusing mechanism turns slightly past infinity to provide accurate focusing under various operating temperatures.
To Next Page