Sony DVS-9000SF - Page 117

117Global Effect Operations
Chapter 11 DME Operations
2 If [Mix], [Auto] or [Depth] is on, turn it off.
3 Set the overlap priority for “Ch1+Ch2+Ch3” or “Ch1+Ch2, Ch3+Ch4” as
follows.
For case “Ch1+Ch2+Ch3”
Under <Priority1> to <Priority3>, press [Ch1], [Ch2], and [Ch3],
respectively, to set the overlap priority.
Priority1: Select the channel with the highest priority.
Priority2: Select the channel with the second highest priority.
Priority3: Select the channel with the lowest priority.
For case “Ch1+Ch2, Ch3+Ch4”
Under <Combiner 1 Priority 1> and <Combiner 1 Priority 2>, press [Ch1]
and [Ch2] respectively, and under <Combiner 2 Priority 1> and
<Combiner 2 Priority 2>, press [Ch4] and [Ch3] respectively, to set the
respective priorities for overlaying the images.
Procedure for combine operation when using the MVE-9000 SDI
interface
Use the following procedure only when the DME being used is the MVE-9000
with an SDI interface.
Priority1: Ch1
Priority2: Ch2
Priority3: Ch3
Ch1
Ch2
Ch3
Combiner1 Priority1: Ch1
Combiner1 Priority2: Ch2
Combiner2 Priority1: Ch4
Combiner2 Priority2: Ch3
Ch2
Ch1
Ch3
Ch4