Chapter 14 Snapshots
208
Snapshot Operations From the Numeric Keypad Control Block
The first pressed button lights green as the reference region, and
subsequently pressed buttons light amber.
For details of the precedence order for becoming the reference region, see
“Regions and registers” in Chapter 1 (Volume 1).
The display shows the name of the reference region and the number of the
register previously recalled for that region.
3
Enter the desired register number from the numeric keypad.
See step 5 (page 206) in “Saving a snapshot from the numeric keypad
control block.”
The entered register number appears in the display.
4
To apply temporary attributes, press the following buttons, turning them
on.
a) Enabled by a setup setting (page 285).
For the setup setting, see “Operation Settings (Operation Menu)” (page
282).
For details of temporary attributes and available attributes, see “Snapshot
Attributes” in Chapter 1 (Volume 1).
Notes
• The cross-point hold and key disable settings are maintained until you
next press the [XPT HOLD] button.
• Applying temporary attributes does not affect the contents of the
register.
• It is not possible to apply temporary attributes to a master snapshot.
5
Press the [ENTER] button.
This recalls the specified snapshot, and the reference region name and
recalled register number appear in the display.
Control block Temporary
attribute to apply
Button
Cross-point control
block
A/B bus cross-point
hold
[XPT HOLD] button in the
background A/B bus
Key cross-point hold
[XPT HOLD] button
a)
Numeric keypad
control block
Effect dissolve [+/–/EFF DISS] button
Auto transition [CLR/AUTO TRANS] button
To Next Page
Loading...
