225Shotbox Register Creation
Chapter 15 Utility/Shotbox
5
Using any of the following methods, select the desired region. You may
select more than one region.
• Press directly on the region display in the status area, turning it to reverse
video.
• Press [ALL] to select all regions.
• To select all switcher-related regions (M/E, P/P, USER), press
[SWR ALL].
• To cancel a selection, press once more to return to the normal display.
6
In the <Assign> group, select the snapshot or effect to be allocated to the
region.
Snapshot: Allocate a snapshot register.
Effect: Allocate a keyframe effect.
• If the selected register is locked, a confirmation message appears asking
whether or not to cancel the operation. Press [OK] to return to the
previous menu display without carrying out the registration.
• If the operation is carried out, the region selected in step 5 is registered
on the master timeline, and the parameters are now valid.
7
Depending on the selection in step 6, set the parameters as follows.
• When a snapshot is selected
• When an effect is selected
a) For the DME region, you can also set register numbers 101 to 199, 201 to 299, and 301 to
399.
8
To run the allocated effect as soon as it is recalled, press [Auto Run],
turning it on.
9
Repeat steps 5 to 8 as required.
10
In the <Store> group, press [Store] to save the setting.
To return to the state before saving the setting
In the <Store> group, press [Undo].
To run the settings to check them
Press [Recall] to run the shotbox.
Knob Parameter Adjustment Setting values
3 Snapshot Snapshot register number 1 to 99
Knob Parameter Adjustment Setting values
3 Effect Keyframe effect number
1 to 99
a)
To Next Page
Loading...
