Chapter 16 Engineering Setup
254
Setup Relating to Operations From the Control Panel
3
In the <Key Select> group, select the keyer to be linked to the transition of
the master.
Note
Linking does not apply to a transition carried out with the downstream key
control block.
Selecting the module to be the reference for device control block
In the <Reference Module> group of the Panel>Config menu, select the
module to be the reference.
• Trackball
•Joy Stick
Assigning the region selection buttons in the numeric keypad
control block
Use the following procedure.
1
In the Panel>Config menu, press [10 Key Region Assign].
The 10 Key Region Assign menu appears. On the left of the status area the
region selection buttons (of the CCP-8000 by default) are shown, and on
the right a list of the assignable regions.
2
In the <Type> group, press [CCP 9000].
The region selection button display changes to display the buttons of the
CCP-9000.
3
Press the indication for the button you want to assign.
The button you pressed turns to reverse video.
Note
This setting is not available for the M/E-1 and P/P.
4
Using any of the following methods, select the region to be assigned.
• Press directly on the list.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
Knob Parameter Adjustment Setting values
1 Region Region selection 1 to 35
To Next Page
Loading...
