Chapter 16 Engineering Setup
292
Setup Relating to Switcher Processor
Setting user regions
Note
If you change the user region settings, the previously stored snapshot data and
keyframe effect data can no longer be used.
Use the following procedure.
1
In the Switcher>Config menu, press [User1-8 Config].
The User1-8 Config menu appears. The status area shows the region names
and assigned user region numbers.
2
Using any of the following methods, select the region you want to set.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
3
In the <User Region Assign> group, select the user region you want to
assign. If you do not want to assign a user region, select [No Assign].
4
Repeat steps 2 and 3 as required to make the settings for other regions.
5
To confirm the setting, press [Execute]. To cancel the setting and return to
the original state, press [Clear] without pressing [Execute].
When you press [Execute], a confirmation message appears.
6
Press [Yes].
This assigns a region to a user region.
Assigning PGM/PST logically to an M/E
Use the following procedure.
1
In the Switcher>Config menu, press [Logical M/E Assign].
The Logical M/E Assign menu appears. The status area shows the physical
M/E and logical M/E organization.
Knob Parameter Adjustment Setting values
1 Region Region selection 1 to ...
To Next Page
Loading...
