315Setup Relating to Switcher Processor
Chapter 16 Engineering Setup
Note
Before the following operations, carry out the procedure described in the
previous item “Setting the interface between the MVE-9000 and the switcher.”
1
In the Switcher>Device Interface menu, press [DME Type Setting].
The DME Type Setting menu appears.
2
Press [DME SDI Interface].
The DME SDI Interface menu appears.
3
Using any of the following methods, select the DME channel to which
operations apply.
• Press directly on the list on the left of the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
4
In the <Select> group, select the AUX bus or reentry to be assigned to the
DME channel.
Aux Bus: Set AUX bus.
Re-Entry: Set reentry.
5
Depending on the selection in step 4, use one of the following methods to
make the setting.
• Press directly on the list on the right of the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
• When Aux Bus is selected
•When Re-Entry is selected
6
Press [Set].
Knob Parameter Adjustment Setting values
1 DME Ch No DME channel selection 1 to 24
Knob Parameter Adjustment Setting values
2 Src No AUX bus number 0 to 48
Knob Parameter Adjustment Setting values
2 Src No Reentry number 0 to 80
To Next Page
Loading...
