379Macro Operations in the Numeric Keypad Control Block and the Keyframe Control Block
Chapter 18 Macros
2
Press the [FROM TO] button in the keyframe control block, turning it on.
The numeric display in the numeric keypad control block shows the
current event number and the indication “TO.”
3
To set the start of the range to other than the current event number, press
the [CLR/AUTO TRANS] button in the numeric keypad control block,
then enter the desired event number with the numeric keypad and press the
[ENTER] button. (This operation is not required when using the current
event number.)
4
Enter the event number for the end of the range and press the [ENTER]
button.
5
Press the [MOD] button in the keyframe control block.
This modifies the specified range of events simultaneously.
Deleting an event
Use the following procedure.
1
Specify the edit point. (See page 377.)
2
To delete multiple events simultaneously, press the [FROM TO] button in
the keyframe control block, then enter the event numbers from the numeric
keypad control block to specify a range to be deleted.
3
Press the [DEL] button.
This deletes the specified events.
Moving events
Use the following procedure.
1
Specify the edit point for the start of the range to be moved. (See page 377.)
2
To move multiple events simultaneously, press the [FROM TO] button in
the keyframe control block, then specify the range in the numeric keypad
control block.
3
Press the [DEL] button.
This temporarily deletes the specified events from the macro, and copies
them to the paste buffer.
To Next Page
Loading...
