Sony GTK-XB60 - Front Panel Block-2

GTK-XB60
16
2-16. FRONT PANEL BLOCK-2
left side
right side
2 Insert a thick screwdriver into the right side
and widen the gap (perform at two places).
Note 2: Be careful because if a screwdriver is
inserted too far in, the speaker unit (WF)
may get damaged.
Note 1:
Make sure to proceed with the top and bottom
sides first because the right and left sides may
damage the sides of the front panel block.
top side
3 Remove the front
panel block in the
direction of the
arrow.
woofer cable
tweeter cable
wood cabinet
front panel block
– Top view –
Note 4:
When installing the front panel block,
be careful not to pinch the three cables.
tweeter cable
woofer cable
FFC
(TOP LED-MAIN)
FFC
(TOP LED-MAIN)
4 front panel block
Note 3:
When installing the
front panel block
remove the used bond and use a new
bond to fix the front panel block.
wood cabinet
bottom side
front panel block
1 Insert a thick screwdriver into the left side
and widen the gap (perform at two places).
Note 2: Be careful because if a screwdriver is
inserted too far in, the speaker unit (WF)
may get damaged.
 Note about installing the front panel block
total ten bosses total eleven bosses
– Front view –
Note 6:
The number of boss holes varies depending
on the destination.
No
boss
hole.
top side
With
boss
hole.
Except US, CNDUS, CND
Note 5:
This boss excludes US
and CND models.
bottom side