No
sound or only a very low-level sound of the
connected component is heard from the
system.
• Press MASTER VOL +and check the
volume level.
• Press MUTING or MASTER VOL
+ to
cancel the muting function.
• Check that the input source is correctly
selected.
• Check that all the cables and cords
of
the
system and the connected components are
fully inserted.
• Check the HDMI setting
of
the connected
components.
No
sound is output from specific speakers.
• Check that the connectors
of
the speaker
cord are fully inserted into the jacks.
• Depending on the sound source that is input
to
the system
or
selected sound field
of
the
system (page 37), no sound is output from
the center speaker.
Sound is interrupted or there is noise.
• Check "Formats supported by this system"
(page 54).
IMAGE
No
image appears on the TV.
• Check that the TV and the system are
connected correctly.
• Check that the
TV
is selected correctly.
• Set the TV to the appropriate input mode.
• Check whether HOMI IN and HOMI
OUT
are connected in reverse.
• Check that the cords are fully inserted into
the jacks on both the component and this
system (pages 23, 25).
No
3D image appears on the TV.
• Depending on the TV or the video
component, 3D images may not be
displayed. Check the 3D image formats
supported by the system (page 55).
When the system is
in
standby mode, there is
no image or sound on the TV.
•
"CTRL
HOMI" is set to "OFF."
• When the system is in standby mode, image
and sound are output from
theHDMI
component selected the last time you turned
off
the system.
If
you want to
playa
component otherthan the HOMI component
you selected last time, play the component
via One-Touch Play,
or
tum
on
the system to
select the HOMI component you want to
enjoy.
• Make sure "PASS
THRU"
is set to "ON" in
the
AMP
menu
if
you connect components
not compatible with "BRAVIA" Sync to the
system (page 41).
The
remote
does
not
function
• Point the remote at the remote sensor
II
on
the system.
• Remove any obstacles in the path between
the remote and the system.
• Replace both batteries in the remote with
new ones,
if
they are weak.
•
Make
sure you select the correct input on the
remote.
OTHER
Control for HOMI does not work properly.
• Check the HOMI connection (page 23).
• Set up Control for HDMI
on
the TV (page
38).
• Make sure the connected component is
compatible with "BRAVIA" Sync.
• Check the Control for HOMI settings on the
connected component. Refer to the
operating instructions supplied
of
the
connected component.
•
If
you change the HDMI connection,
connect/disconnect the AC power cord
(mains lead), or
if
there is a power failure,
repeat the procedures
of
""BRA
VIA" Sync
Features" (page 38).
• When you plug in or unplug the AC power
cord (mains lead), wait
15
seconds or more
before operating the system.
conunued--------
53
us
To Next Page
Loading...
