Sony ICF-SW1000TS - Listening to the Radio; Scan Tuning

Basic Operations6
EN
AM
PAGE
1
2
3
kHz
FWD
AM
PAGE
1
2
3
kHz
FWD
FM
PAGE
1
2
3
MHz
FWD
AM BAND
FM/AM
ON/
OFF
123
456
789
0
Listening to the radio—Scan tuning
To manually tune in to the desired broadcast staion, refer to
“Manual tuning” on page 12.
To immediately tune in to the desired broadcast station, refer to
“Direct tuning” on page 14.
To preset a broadcast station for instant recall, refer to “Preset
tuning” on page 15.
1 Press RADIO POWER ON/OFF.
The radio turns on.
2 Press FM/AM to select either FM
or AM.
Select AM to listen to SW, MW or LW.
3 When you select AM, press
–
1¿
or ÷1
+
while pressing AM
BAND to select MW, LW, or
meter band (SW)*.
Skip this step and proceed to step 4 if
you wish to listen to FM.
* For details on the meter band, refer to
“Meter bands and SW” on page 13.
4 Press and hold
–
1¿ or ÷1
+
and
release when scanning of the
frequency begins.
When a broadcast station is received
automatically, scanning pauses for
about 2 seconds. Then, scanning
resumes to tune in to the next
broadcast station.
Scanning repeats in a cycle within the
meter band frequency range (see page
13). Scanning during SSB reception
repeats in a cycle within the 150-29999
kHz frequency range.*
3,4,5
3
2
1
VOLUME
The minimum
frequency allocation for
each band is displayed.
+
* Not applicable for the Saudi
Arabian model.