Sony ILCA-99M2 - Page 369

Menu item details
TC/UB Disp. Setting:
Sets the display for the counter, time code, and user bit.
TC Preset:
Sets the time code.
UB Preset:
Sets the user bit.
TC Format:
Sets the recording method for the time code. (Only when [NTSC/PAL Selector] is set to NTSC.)
TC Run:
Sets the count up format for the time code.
TC Make:
Sets the recording format for the time code on the recording medium.
UB Time Rec:
Sets whether or not to record the time as a user bit.
How to set the time code (TC Preset)
How to reset the time code
You can also reset the time code (00:00:00:00) using the RMT-VP1K remote commander (sold
separately).
How to set the user bit (UB Preset)
How to reset the user bit
MENU → (Setup) → [TC/UB Settings] → [TC Preset].
1.
Press the multi-selector up/down and select the first two digits.
The time code can be set between the following range.
When [60i] is selected: 00:00:00:00 to 23:59:59:29
2.
When [24p] is selected, you can select the last two digits of the time code in multiples of four from 0 to 23
frames.
When [50i] is selected: 00:00:00:00 to 23:59:59:24
*
Set the other digits following the same procedure as in step 2, then press in the center of the
multi-selector.
3.
MENU → (Setup) → [TC/UB Settings] → [TC Preset].
1.
Press the (Delete) button to reset the time code (00:00:00:00).
2.
MENU → (Setup) → [TC/UB Settings] → [UB Preset].
1.
Press the multi-selector up/down and select the first two digits.
2.
Set the other digits following the same procedure as in step 2, then press in the center of the
multi-selector.
3.
MENU → (Setup) → [TC/UB Settings] → [UB Preset].
1.
Press the (Delete) button to reset the user bit (00 00 00 00).
2.