Sony MHC-RV555D - Troubleshooting; General

MHC-RV555D/RV333D/RV222D.GB.4-136-609-11(1)
82
GB
Additional Information
Troubleshooting
Should you encounter a problem with
your system, do the following:
1 Make sure the power cord and
speaker cords are connected
correctly and rmly.
2 Find your problem in the
troubleshooting checklist below and
take the indicated corrective action.
If the problem persists aer doing all
of the above, consult your nearest Sony
dealer.
If “PROTECT” appears on the
display
Immediately unplug the power cord,
and check the following items.
 If your system has a voltage
s
elector, is the voltage selector set
to the correct voltage?
 Are you using only the supplied
s
peakers?
 Are the + and  speaker cords
s
hort-circuited?
 Is anything blocking the ventilation
h
oles on the rear of the system?
Aer you have checked these above
items and found to be all right, wait
for 60 seconds and reconnect the
power cord, and then turn on the
system. If the issue persists, contact
your nearest Sony dealer.
General
The display starts ashing as soon
as you plug in the power cord even
though you have not turned on the
system.
 Press DISPLAY once while the system
i
s o. e demonstration disappears.
“– –:– –” appears in the display.
 A power failure has occurred. Set the
c
lock (page 29) and timer settings
(page 73) again.
The system does not turn on.
 Is the power cord plugged in?
 Is the voltage selector set correctly to
m
atch the local power line voltage?
(For models with a voltage selector
only)
The clock or timer setting is canceled.
 e power cord is disconnected or a
p
ower failure occurred. Redo “Setting
the clock” (page 29). If you have set the
timer, redo “Using the timers” (page
73).
There is no sound.
 Press VOLUME + repeatedly (or
turn MASTER VOLUME on the unit
clockwise).
 e headphones are connected to the
P
HONES jack.