26
GB
MHC-RV7 4-240-085-11 (1)
Falling asleep to music
— Sleep Timer
You can set the system to turn off at a preset
time, so you can fall asleep to the music.
Press SLEEP on the remote.
Each time you press the button, the minute
display (the turn-off time) changes as follows:
AUTO* t 90 t 80 t 70 t … t 10 t
OFF
* The power turns off when the current CD or tape
finishes playback (for up to 100 minutes).
To
Check the remaining
time
Change the time to turn
off
Cancel the Sleep Timer
Do this
Press SLEEP once.
Press SLEEP
repeatedly to select the
time you want.
Press SLEEP
repeatedly until
“SLEEP OFF” appears.
Waking up to music
— Daily Timer
You can wake up to music at a preset time
every day. Make sure you have set the clock
(see “Setting the clock” on page 8).
1 Prepare the music source you want to
play.
• CD: Load a CD. To start from a specific
track, make a program (see “Programming
the VIDEO CD/CD tracks” on page 12).
• Tape: Load a tape with the side you want
to play facing forward.
• Radio: Tune in the preset station you
want (see “Listening to the radio” on page
17).
2 Adjust the volume.
3 Press CLOCK/TIMER SET on the
remote.
“DAILY1 SET” appears.
4 Press V or v repeatedly to select
“DAILY1 SET (or DAILY2 SET)”, then
press ENTER.
“ON” appears and the hour digits flash in
the display.
5 Set the time to start playback.
Press V or v repeatedly to set the hour,
then press ENTER.
The minute indication flashes.
Press V or v repeatedly to set the minute,
then press ENTER.
The hour indication flashes again.
6 Set the time to stop playback following
step 5 above.
6 Press hH to start playing the source
to be recorded.
Start singing along with the music.
After you have finished.
Turn MIC LEVEL to MIN and disconnect the
microphone from MIC jack.
Tips
• You can mix and record sound from microphone
after step 2. To record the sound see “Recording
Manually” on page 19. To stop recording, press x.
• If acoustic feedback (howling) occurs, move the
microphone away from the speakers or change the
direction of the microphone.
• If you want to record your voice through the
microphone only, you can do so by selecting the
CD function and not playing a CD.
• When high level sound signals are input, the unit
automatically adjust the recording level to prevent
distortion of the recorded sound signals (Auto
Level/ Control Function).
Note
The microphone does not function during High Speed
Dubbing.
Mixing and recording sounds
(continued)
To Next Page
Loading...