59
MHC-V44D
SECTION 8
ELECTRICAL PARTS LIST
A-2083-918-A DAMP BOARD, COMPLETE
*********************
< IC >
IC2001 6-718-105-01 IC TAS5534DGGR
IC2002 6-721-742-01 IC TAS5614LA
IC2003 6-721-742-01 IC TAS5614LA
*************************************************************
IR BOARD
********
< IC >
IC3300 6-600-766-01 IC PNA4823M01S0 ( )
*************************************************************
MIC BOARD
*********
< CONNECTOR >
CN3500 1-784-921-11 PIN, CONNECTOR 4P
< DIODE >
D3500 6-500-400-01 DIODE BAV99-215
D3501 6-500-400-01 DIODE BAV99-215
D3503 6-502-961-01 DI DA2J10100L
D3504 6-502-961-01 DI DA2J10100L
< IC >
IC3500 8-759-909-71 IC BA4558F
< JACK >
J3500 1-822-967-12 JACK (MIC1)
J3501 1-822-967-12 JACK (MIC2)
JR35002 1-216-296-11 SHORT CHIP 0
JR35003 1-216-296-11 SHORT CHIP 0
*************************************************************
9 A-2126-571-A MOTHERBOARD BOARD, COMPLETE
(for SERVICE) (MY)
9 A-2121-647-A MOTHERBOARD BOARD, COMPLETE
(for SERVICE) (AR, LA9)
9 A-2121-648-A MOTHERBOARD BOARD, COMPLETE
(for SERVICE) (RU)
9 A-2121-649-A MOTHERBOARD BOARD, COMPLETE
(for SERVICE) (AUS)
9 A-2121-650-A MOTHERBOARD BOARD, COMPLETE
(for SERVICE) (TH)
9 A-2121-651-A MOTHERBOARD BOARD, COMPLETE
(for SERVICE) (E12)
9 A-2121-652-A MOTHERBOARD BOARD, COMPLETE
(for SERVICE) (E93, E4)
******************************
*************************************************************
MS-476 BOARD
************
When the MS-476 board is defective, exchange the entire CDM90 ASSY.
*************************************************************
PARTY LED BOARD
***************
< CONNECTOR >
CN004 1-774-730-21 PIN, CONNECTOR (PC BOARD) 3P
< DIODE >
D003 6-504-102-01 DI LD CN5M-4Q4R-35-1
D005 6-504-104-01 DI LT CN5M-GAHB-25-1
*************************************************************
Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark
When indicating parts by reference num-
ber, please include the board name.
Note:
• Due to standardization, replacements in
the parts list may be different from the
parts specifi ed in the diagrams or the com-
ponents used on the set.
• -XX and -X mean standardized parts, so
they may have some difference from the
original one.
• RESISTORS
All resistors are in ohms.
METAL: Metal-fi lm resistor.
METAL OXIDE: Metal oxide-fi lm resistor.
F: nonfl ammable
• Items marked “*” are not stocked since
they are seldom required for routine ser-
vice.
Some delay should be anticipated when
ordering these items.
• SEMICONDUCTORS
In each case, u: μ, for example:
uA. . : μA. . , uPA. . , μPA. . ,
uPB. . : μPB. . , uPC. . , μPC. . ,
uPD. . : μPD. .
• CAPACITORS
uF: μF
• COILS
uH: μH
• Abbreviation
AR : Argentina model
AUS : Australian model
E4 : African model
E12 : 220-240 V AC area in E model
E93 : 240 V AC area in E model
LA9 : Latin-American model
MY : Malaysia model
RU : Russian model
TH : Thai model
The components identifi ed by mark 0
or dotted line with mark 0 are critical for
safety.
Replace only with part number specifi ed.
DAMP IR
MIC
MOTHERBOARD PARTY LED
The components identifi ed by mark 9
contain confi dential information.
Strictly follow the instructions whenever the
components are repaired and/or replaced.
Note 1: When the DAMP board is replaced, spread the com-
pound referring to “NOTE OF REPLACING THE IC2002
and IC2003 ON THE DAMP BOARD AND THE COM-
PLETE DAMP BOARD” on servicing notes (page 5).
Note 3: When the complete MOTHERBOARD board is replaced,
refer to “NOTE OF REPLACING MOTHERBOARD
BOARD OR BLUETOOTH MODULE OR RC-S730 (WW)
BOARD” on page 6.
Note 2: When the DAMP board is replaced, spread the bond re-
ferring to “BOND FIXATION OF ELECTRIC PARTS” on
servicing notes (page 7).
Note 4: When the SMPS board is replaced, spread the com-
pound referring to “NOTE OF REPLACING THE IC965,
Q908 AND Q909 ON THE SMPS BOARD” on servicing
notes (page 6).
Note 5: When the SMPS board is replaced, spread the bond re-
ferring to “BOND FIXATION OF ELECTRIC PARTS” on
servicing notes (page 7).
Ver. 1.1
To Next Page
Loading...
