MHC-V77DW
11
Note: Follow the disassembly procedure in the numerical order given.
2-2. REAR COVER ASSY
2-3. SIDE-L PANEL
2 three screws
(flathead (TP))
2 four screws
(flathead (TP))
3 three screws
(flathead (TP))
5 Slide the panel side, L
in the direction of the arrow.
6 panel side, L
4 Lift up the top panel section
in the direction of the arrow.
1 two screws
(+BVTP 3 u 8)
3 cover, rear assy
Note 2: There is cushion rear at the top of the cover, rear assy.
Remove the cover, rear assy gently to avoid from
being broken.
1 three screws
(flathead (TP))
2 three screws
(+BVTP 3 u 10)
2 five screws
(+BVTP 3 u 10)
Note 1: When the cover rear assy is disassembled from the
set, refer “NOTE OF REPLACING THE CUSHION
REAR ON THE COVER REAR ASSY” on page 5.
To Next Page
Loading...
