Sony MHC-V77DW - 2 CH DAMP Board

MHC-V77DW
18
2-11. 2CH DAMP BOARD
clampcushion (QJ, S)
2CH DAMP board
0 two screws
(+PTPWH 2.6 u L (DIA8.0)
:LUHVHWWLQJ
rear
side
2 Wire is removed
from the clamp.
3 CN1004 (8P)
6 CN1003
(6P)
7 three screws
(+BVTP 3 u 8)
9 plate, shield D-AMP
qf two screws
(+BVTP 3 u 8)
qh bracket, heat sink
qd 2CH DAMP board
7 one screw
(+BVTP 3 u 8)
qa heat sink, AMP
qs sheet, thermal
8 clamp
qg Remove the
bracket, heat sink
in the direction
of the arrow.
1 wire (flat type)
(17 core) (CN1001)
Note 2: When you install the connector, please install them correctly.
There is a possibility that this machine damages when not
correctly installing it.
Insert is shallow
Insert is straight
to the interior.
connector
Insert is incline
connector
connector
connector
connector connector
Note 1: When installing the wire (flat type), ensure that
the colored line is not slanted after insertion.
colored line
colored line
Insert is straight to the interior. Insert is incline
wire (flat type) wire (flat type)
connectorconnector
OK
NG
OK NG NG
4 cushion, seal
5 core, ferrite
$(38.58
0<$86