Sony MHC-V77DW - Getting Started; Hooking Up the System Securely

MHC-V77DW
19
2-12. BENTEN-MOTHERBOARD BOARD, 89G BOARD
1 CN6401
(4P)
6 CN6901 (9P)
7 CN6851 (3P)
2 filament tape
4 CN6802 (3P)
9 four screws
(+BVTP 3 u 8)
qa two screws
(+BVTP 3 u 8)
qs 89G board
0 BENTEN-MOTHERBOARD board
BENTEN-MOTHERBOARD board
3 ANTENNA board
harness coaxial connector
ANTENNA board
harness coaxial connector
5 wire (flat type)
(6 core) (CN6202)
8 wire (flat type)
(29 core) (CN7001)
Note 3: When you install the connector, please install them correctly.
There is a possibility that this machine damages when not
correctly installing it.
Insert is shallow
Insert is straight
to the interior.
connector
Insert is incline
connector
connector
connector
connector connector
Note 2: When installing the wire (flat type), ensure that
the colored line is not slanted after insertion.
colored line
colored line
Insert is straight to the interior. Insert is incline
wire (flat type) wire (flat type)
connectorconnector
OK
NG
OK NG NG
:LUHVHWWLQJ
rear side
Note 1: When the BENTEN-MOTHERBOARD board is replaced,
refer to “IMPORTANT NOTE OF REPLACING THE
BENTEN-MOTHERBOARD BOARD” on page 5 and “IM-
PORTANT NOTE OF DHSR-SY30 AT BENTEN-MOTH-
ERBOARD BOARD” on page 6.