Applicable Models
PFV-HD50A HD Digital Video Interface Unit
Specifications
Inputs/outputs
Digital video signal input:
DIGITAL IN VIDEO connector (BNC type) (1)
HD component serial digital signal
conforming to SMPTE291M/292M/299M
Input impedance:
75 Ω, unbalanced
Input return loss:
15 dB or more (5 MHz to 1.485 GHz)
Transmission loss:
20 dB or less (at 742.5 MHz)
Cable length:
100 m max. (When using a 5C-FB coaxial
cable or PD-3079 COOPER RG-6/U type
Super Low Loss Digital Video Coax or
equivalents)
Digital audio signal inputs:
DIGITAL IN AUDIO connectors (BNC type)
(4)
AES/EBU-format signal
75 Ω, 1 Vp-p, unbalanced
Digital signal outputs:
DIGITAL OUT connectors (BNC type) (2)
HD component serial digital signal
conforming to SMPTE291M/292M/299M
Output signal amplitude:
800 m Vp-p 610% (at 75 Ω)
Output impedance:
75 Ω, unbalanced
Output return loss:
15 dB or more (5 MHz to 1.485 GHz)
Jitter:
Within 673 ps (timing jitter)
Within 135 ps (alignment jitter)
Audio delay
Setting method:
Delay range is set by the on-board rotary
switch; the offset delay time is set by the
on-board DIP switch
Variable range:
0 to 157 samples
Offset delay time:
0 or 1 frame
Digital input/output system delay
Video:
1.6 µs (without lip-sync)
General
Power requirements:
+5 V DC: 1.6 A, -5 V DC: 1.3 A
(Supplied from the PFV-HD300/HD50A
Interface Unit)
Power consumption:
Approx. 15 W
Operating temperature:
5 to 40 °C (41 to 104 °F)
Storage temperature:
-20 to 55 °C (-4 to 131 °F)
Humidity:
10 to 90 % (without condensation)
Dimensions:
Board (H x W):
194 x 310 mm
(7 3/4 x 12 1/4 inches)
Connector panel (H x D x W):
218 x 98 x 25 mm
(8 5/8 x 3 7/8 x 1 inches)
Mass
Board:
700 g (1 lb 8.7 oz)
Connector panel:
300 g (11 oz)
HD SD IN
HD SDI OUT 1
HD SDI OUT 2
S/P P/S
AES/EBU IN 1
AES/EBU IN 2
AES/EBU IN 3
AES/EBU IN 4
A/V
MUX
Auto
EQ
The HKPF-105M is a video/audio multiplexer board that
multiplexes four AES/EBU format digital audio signals (8
channels) with an SMPTE291M/292M/299M format
component serial digital video signal. Two outputs of the
multiplexed signal are provided. By cascading two
HKPF-105M boards, a further four AES/EBU signals can
be multiplexed onto one HD signal, making a total of eight
pairs/sixteen channels. Automatic equalization is provided
for input cable lengths of up to 100 m (5C-FB or PD-3709
Cooper RG-6/U cable or equivalents).
Features
* Multiplexes two AES/EBU signals with an HD
component serial digital video signal * Selection of the
audio group to be multiplexed * Audio delay function - one
video frame * Support SMPTE292M formats *
1035(1125)/60i, 59.94i * 1080(1125)/60i, 59.94i, 50i *
1080(1125)/30PsF, 29.976PsF, 25PsF, 24PsF, 23.976PsF
* 720(750)/60P, 59.94P * Auto selection of SMPTE292M
video formats * Format indication on the front panel *
Status output
The HKPF Series function boards install in the PFV-HD Series Interface Units.
105
Interface Processor D Series
Interface Processor D Series
HKPF-105M HD Audio/video Multiplexer Board
Rear Panel
*SGC_0099-0116 02.3.16 5:04 PM Page 105
To Next Page
Loading...
