406
2
In the <Device> group, select the target switcher to set.
The status area shows the set status of the output
connectors for slots in which an XKS-S8167/
XKS-S9167 is installed.
3
In the status area, select the target output connector to
set.
4
In the <Output> group, select whether to enable or
disable the output.
Enable: Enable signal output.
Disable: Disable signal output.
To enable all output connectors
Press [All Enable].
To clear the setting
Press [Clear].
5
Press [Execute].
6
Check the message, then press [Yes].
To Next Page
Loading...
