ICP-X7000
2-4 (E)
6. Connect the fine-wire coaxial cable to the connector on
the operation module to be installed newly.
7. Fit the operation module to be installed in the location
from which the operation module was removed in step
4, and tighten four screws (with stopper) on both sides
to secure the operation module.
8. Reinstall the operation module or the blank panel
removed in steps 1 to 3.
Installing the trackball
For MKS-X7031TB, the trackball must be installed after
the operation module is installed in step 1 to 8 in “Installing
operation module to the main panel” above.
Perform the following procedure to install the trackball.
9. Turn the ball holder counterclockwise (3) to unlock it.
10. Detach the ball holder.
11. Install the trackball and the ball holder.
12. Turn the ball holder clockwise (2) until it locks.
Module covers
Connector
Operation module
Screws
(with stopper)
Screws
(with stopper)
Fine-wire coaxial cable
Ball holder
Operation module
(MKS-X7031TB)
Trackball
Ball holder
Operation module
(MKS-X7031TB)
To Next Page
Loading...
