Sony MKS-X7033 - Example of Connection of Serial Tally through a Network; Connection Example of Network AUX Remote

ICP-X7000
1-61 (E)
1-15-5. Example of Connection of Serial Tally through a Network
t
. Set system interface units (to be connected to external devices) in the tally master.
. For the serial tally setting, refer to “Setting of Serial Tally” in the user’s guide.
. For setting the UTIL LAN IP address of system interface units, refer to “1-17-3. Network Settings for Connected
Devices.”
1-15-6. Connection Example of Network AUX Remote
t
. The following shows a connection example of the NS-BUS remote control panel to be used as an AUX remote controller
without using the system controller (PWS-110NM1/PWS-110RS1).
. This connection cannot be used together with the NS-BUS connection (shown in “1-15-3. Example of Connection to
NS-BUS”).
. Only two models (MKS-R3210 and MKS-R1620) of NS-BUS remote control panel can be used in this connection.
. Up to 16 NS-BUS remote control panels per switcher control panel are connectable in this connection.
(Example: Up to 64 NS-BUS remote control panels are connectable in a system including four switcher control panels.)
MVS UTIL
System Interface Unit
MKS-X2700
Switcher Control Station
PWS-100SC1/PWS-110SC1
or MKS-X7700
Controller
(Serial Tally over IP)
LAN1
Switcher Control Station
PWS-100SC1/PWS-110SC1
LAN2
LAN1
LAN1
32 Button Remote Control Panel
MKS-R3210
16 Button LCD Remote Control Panel
MKS-R1620