Sony MVS-3000 System - Using Multi Viewer; Setting Multi Viewer Output

25
Using Multi Viewer
Preparation
3 Set a monitor for preview output.
a In the <Output Assign> group, select [Re-Entry
Source].
b In the [Out#] column in the list on the left, select the
number for the OUTPUTS connector connected to
the monitor.
In this example, select “2”.
c In the [Src#] column in the list on the right, select
the preview output.
In this example, select “P/P PVW”.
d Press [Set].
The output signal is assigned, and “P/P PVW” is
displayed for output 2 in the [Out#] column.
Using Multi Viewer
The screen of a monitor connected to the MVS system can
be split to view multiple video signals simultaneously.
The screen can be split into four, ten, or sixteen
subscreens.
There are two multi viewer systems, Multi Viewer 1 and 2,
to which you can assign signals independently.
This section describes the procedure for setting Multi
Viewer 1.
Setting Multi Viewer Output
To use multi viewer, you must assign the multi viewer
output to the OUTPUTS connector connected to the
monitor in advance.
1 Display the menu.
a Open the Engineering Setup >Switcher >Output
menu (7333).
b Press [Output Assign].
The Output Assign menu (7333.1) appears.
Subscreen signals
Subscreen signals
Split into four
Split into ten
Subscreen signalsSplit into sixteen