Sony MVS-3000 System - Assigning Key Selection Functions to Next Transition Selection Buttons

38
Assigning 8-Keyer Buttons (MVS-6530 only)
Preparation
3 Assign a key to a button number.
a In the [Button#] column of the list on the left, select
the button number.
In this example, select “5”.
Numbers “5” to “8” are set to “No Assign” by
factory default.
b In the list on the right, select the key to assign.
In this example, select [KEY5].
c Press [Set].
d Repeat steps a to c to assign [KEY6] to [KEY8]
to button numbers “6” to “8”, respectively.
Assigning Key Selection Functions
to Next Transition Selection Buttons
You can make assignments so that key 1 to key 8 can be
selected using next transition selection buttons in the
transition control block.
1 Display the menu.
a Open the Engineering Setup >Panel >Config
>Transition Module menu (7321.9).
2 Select the target bank.
Transition Module menu
a In the <Bank Select> group, select [P/P].
3 Assign a key to a button.
a In the button diagram on the left, select the target
button.
In this example, select the [KEY1] button in [Next
Transition].
b In the list on the right, select the key to assign.
In this example, select [KEY1/5].
c Press [Set].
d Repeat steps a to c to assign [KEY2/6], [KEY3/
7], and [KEY4/8] to buttons [KEY2], [KEY3], and
[KEY4], respectively.
4 Assign the [SHIFT] and [ADD] functions to buttons.
a In the button diagram on the left, select the target
button.
In this example, select a blank button.
b In the list on the right, select [SHIFT].
c Press [Set].
d Repeat steps a to c to assign [ADD].
Next Transition
Set
Blank buttons
Bank Select